Anchor Tester Kit is an Anchorage Verification Device for proof-testing construction anchorage applications.


Kit includes:

  • VERI5000 tester with fixed analog gauge 6,744lbf

  • 150 Load Spreading Bridge with 75mm Hex extension legs

  • Ratchet Spanner 22mm

  • Single wrench 10mm

  • Bolt test adaptor

  • M12 Locking adaptor: secured inside jaw

  • 4 x Threaded Button adaptors: 1/4", 5/16", 3/8" & 1/2"

  • 6 x Slotted Button adaptors:4.5, 5.5, 6.5, 8.5, 10.5 & 12.5

  • 5/8" and 3/4" Threaded Stud Adaptor

  • Ball driver 3mm

  • 2.5mm Allen Key and Spare screws


Kit supplied in a padded carrying case with 12 months calibration and full operating instructions.


ATK-A - comes with Analog 0-30kN/6,744lbf Gauge


VERI5000 Brochure

2022 List Price

What To Proof-Test To and Why 

Rebar Strength



VERI5000™ requires the user to read the manual in its entirety prior to use of the equipment. User should wear appropriate personal protective equipment when performing a proof-test. After each proof test a Competent Person or person who has been trained as a Competent Equipment Inspector must inspect the equipment for cracking, breaking, or permanent deformation of the structure and equipment (OSHA 1910.66 and 1926.502) If the Equipment Inspector or Competent Person is inspecting another manufacturers product that he or she has not been trained on, they must refer to the manufacturer’s instruction manual for the proper inspection of the anchor. Some anchors may deform during a proof-test and still hold, therefore meeting their intended purpose.  Please consult the Manufacturer of the anchor with any questions on the product and as always, remove any deformed anchors from use. When choosing what to proof-test to, picking the lowest force that meets the requirements will greatly reduce the risk of breaking, cracking or deforming anchors.  Pulling anchors to the maximum of 5000lbs may deform the anchor. VERI5000 and or Hydrajaws are not responsible for any damage to the structure being tested.